Open folder "Bitmaps"
Copy folder "embroidery" and install it to:
OS(C:)>Mach3>Bitmaps
Copy "embroidery.set" and install it to:
OS(C)>Mach3
Copy "M786.m1s" and install it to:
OS(C:)>Mach3>macros>yourprofile>
X axis, Y axis are regular axes.
Z axis is axis for a needle.
A axis is for zigzag stitches ( if your machine has an additional stepper motor for this feature, if not - disable this axis)
B axis is for multi head axis to change the colors.( if machine is single head, disable this axis)
If you have to home all axis with a different order, edit VBS for the button "All Home" 
The Needle button is for Z axis. Activating the button, it starts "ref Z axis and zero Z" axis at same time. 
(You should have a limit switch installed for a needle in order to ref Z axis.)
You can edit VBS for this button too.
Hoop1 is G 54, Hoop2 is G 55
copy File M786.m1s and save to:
OS(C:)>Mach3>macros>yourprofile>
copy File macropump.m1s and save to 
OS(C:)>Mach3>macros>yourprofile>
In General Config. enable macropump (Run Macro Pump)
Restart Mach3
If you're using Nr 10 for 1 full rev., then everithyng is set OK
If you're using any 1-9 Nr. - edit the file macropump.m1s like this:
Operator/ VB Script Editor/macropump.m1s
Stitches = (CurrentZ)/2+0.5


make a lot of stitches  :)

